Milwaukee 49-40-6110 Manual Del Operador página 4

ASSEMBLY
Use only recommended diamond
WARNING
abrasive wheels. Other accesso-
ries may be hazardous.
Attaching the Shroud
1. Unplug or remove the battery pack from the
grinder.
2. Remove the side handle, all accessories and the
grinder guard.
3. Turn the shroud knob to open the shroud and
expose the collar.
4. Place the collar on the grinder spindle. Make sure
it aligns properly. Install according to the guard
assembly instructions in the tool manual.
NOTE: The shroud will not work on grinders that do
not have the same spindle collar design.
5. WARNING! Always adjust the guard to provide
the operator with maximum protection while
operating. See tool manual for reference. Select
the proper cutting angle for the application.
6. WARNING! Only install diamond abrasive wheels
according to instructions. Flap discs and resin
bonded grinding wheels are not acceptable for
this shroud. Install the applicable diamond abra-
sive wheel according to the instructions in the tool
manual.
7. Close the wheel cover and tighten the shroud
knob securely.
8. Adjust the depth gauge for the chosen depth of
cut.
9. Reinstall the grinder side handle. WARNING!
Do not use the grinder without the side handle
installed.
10. Attach the hose clip adaptor and dust extractor
hose to the shroud.
OPERATION
To reduce the risk of fire and in-
WARNING
jury, do not use to pick up flam-
mable or combustible materials. Empty dust box
completely before use.
To reduce the risk of injury, wear safety goggles
or glasses with side shields.
To reduce the risk of injury, wear a dust mask or
use an OSHA compliant dust extraction solution.
Before using the cutting dust shroud, read
this operator's manual, your tool and vacuum
manuals, and all labels on the shroud, tool, and
vacuum.
1. Turn the dust extractor to "automatic-cleaning"
mode.
2. Align the shroud so that it is flush with the material
and begin the cut.
NOTE: Operate on concrete, brick, or tile surfaces
only. Do not operate on wood or metal surfaces.
4