Maintenance & Adjustment - Troy-Bilt Tuffy Manual De Uso

Maintenance & Adjustments
Maintenance
WARNING:
repairs, disengage PTO, move shift lever into neutral
position, set parking brake, stop engine and remove
key to prevent unintended starting.
Engine
Refer to the Engine Owner's Manual for engine maintenance
instructions.
Check engine oil level before each use as instructed in the Engine
Owner's Manual packed with your unit. Follow the instructions
carefully.
Changing Engine Oil On Briggs & Stratton Models
For draining oil from the engine's crankcase, a plastic oil drain
sleeve is packed with this Operator's Manual. To drain the oil,
proceed as follows:
1. Run the engine for a few minutes to allow the oil in the
crankcase to warm up. Warm oil will flow more freely and
carry away more of the engine sediment which may have
settled at the bottom of the crankcase. Use care to avoid
burns from hot oil.
2. Open the tractor's hood and locate the oil drain port on the
right side of the engine and the oil fill cap on the topside of
the engine.
3. Unscrew the oil fill cap and remove the dipstick from the oil
fill tube.
4. Snap the small end of oil drain sleeve onto the space
provide around the oil drain plug. See Fig. 6-1.
5. Remove drain plug and drain oil into a suitable container
with a capacity of no less than 64 oz.
18
Before performing any maintenance or
Figure 6-1
6. Reinstall the oil drain plug securely. Be careful not to
overtighten.
4. Refill the engine with new motor oil as instructed in the
Engine Owner's Manual packed with your unit.
IMPORTANT:
Refer to the Engine Owner's Manual packed with
your unit for information regarding the quantity and proper
viscosity of motor oil.
Changing The Engine Oil on Kohler Engine Models
To complete an oil change, proceed as follows:
1. Run the engine for a few minutes to allow the oil in the
crankcase to warm up. Warm oil will flow more freely and
carry away more of the engine sediment which may have
settled at the bottom of the crankcase. Use care to avoid
burns from hot oil.
2. Open the tractor's hood and locate the oil drain port on the
right side of the engine.
3. Pop open the protective cap on the end of the oil drain
valve to expose the drain port. See Fig 6-2.
4. Remove the oil fill cap/ dipstick from the oil fill tube.
5. Push the oil drain hose (packed with this manual) onto the
oil drain port. Route the opposite end of the hose into an
appropriate oil collection container with at least a 2.5 quart
capacity, to collect the used oil.
6. Rotate the drain valve counter-clockwise and release to
Figure 6-2
drain the oil. See Fig 6-2.
7. After the oil has finished draining, push the end of the oil
drain valve back in, until the tabs click into place. Re-cap
the end of the oil drain valve to keep debris from entering
the drain port.
6