Bit-Locking Function; Belt Hook - Greenlee LDD-144 Manual De Instalación

Operation—Power Tool (cont'd)
Choose a low or high speed to suit the application. The
lower speed setting allows for higher torque operation.
When the word "High" is visible, the tool is in the high
speed setting. When the word "Low" is visible, the tool
is in the low speed setting.
LOW
The more the variable speed control trigger is pulled,
the higher the speed becomes.
Note: When the brake operates, a braking sound may
be heard. This sound indicates engagement of the bit
lock.

Bit-locking Function

With the trigger switch not engaged and a screwdriver
bit locked in place, the tool can be used as a manual
screwdriver (up to 199 in-lb or 22.6 Nm).
Note: There will be a little play in the chuck, but this is
not a malfunction.
This feature is handy for tightening screws that require
more torque than the maximum torque of the driver
(position on the clutch), for confirming the tight-
ness of a screw, or to loosen an extremely tight screw.
HIGH
12

Belt Hook

• Be sure to attach the belt hook securely to the
main unit with the screw firmly fastened. When
the belt hook is not firmly attached to the main
unit, the hook may disconnect and the main unit
may fall.
• Periodically check screw for tightness. If found to
be loose, tighten firmly.
• Be sure to attach the belt hook firmly and
securely onto a waist belt or other belt. Pay atten-
tion that the unit does not slip off the belt.
• When the main unit is held by the belt hook, avoid
jumping or running with it. Doing so may cause
the hook to slip and the main unit may fall.
• When the belt hook is not used, be sure to return
it to the storing position. The belt hook may catch
on something.
• When the unit is hooked onto the waist belt by the
belt hook, do not attach driver bits to the unit. A
sharp edge object, such as a drill bit, may cause
injury or an accident.
Failure to observe these warnings could result in an
accident or injury.
The belt hook can be attached to either side of the
unit.
To remove the hook:
1. Remove the nut.
2. Draw out the hook.
To attach the hook:
1. Insert the hook in the other side.
2. Tighten the nut fully so that it is securely
fastened.