Operation-Power Tool - Greenlee LDD-144 Manual De Instalación

Operation—Power Tool
• To prevent excessive temperature increase of the
tool surface, do not operate the tool continuously
using two or more battery packs. The tool needs
cool-off time before switching to another pack.
• Do not close up vent holes on the sides of the
body during operation. Otherwise, the machine
function is adversely affected to cause a failure.
• Do NOT strain the tool (motor). This may cause
damage to the unit.
• To prevent burns, use the tool in such a way as
to prevent the air from the body vent holes from
blowing directly onto your skin.
• If the tool body becomes very hot or does not
work properly, remove the battery pack and do
not use. Have it checked by an authorized service
center.
Symbol
V
n
o
rpm
Explanation
Volts
Direct current (DC)
No load speed
Drill setting
Revolutions per minute
• Do not use the power tool if the switch does
not turn it on and off. Any power tool that cannot
be controlled with the switch is dangerous and
must be repaired.
• Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such pre-
ventive safety measures reduce the risk of start-
ing the power tool accidentally.
• When storing or carrying the tool, set the Forward/
Reverse switch to the center position (switch
lock). Accidentally starting the tool may result in
injury.
• Do not strain the tool by holding the speed control
trigger halfway (speed control mode) so that the
motor stops. The protection circuit will activate
and may prevent speed control operation. If this
happens, release the speed control trigger and
squeeze again for normal operation.
• Be careful not to get dust inside the chuck.
• Do not drop the tool.
Failure to observe these precautions may result in
injury or property damage.
9
LDD-144