Dyna-Glo DGE530SSP Manual De Instrucciones página 14

ASSEMBLY INSTRUCTIONS
13. Remove 2 pre-assembled screws from the
bracket in the side burner valve assembly.
Secure side burner valve assembly and side
burner control knob bezel (P) to the side table
by placing the side burner valve assembly
under the side table and sliding the valve stem
through the hole in the side table front facing
and hold in place. Place the side burner
control knob bezel (P) over the valve stem on
the outside of the side table front facing, lining
up the holes in the bezel with the holes in the
valve assembly. Secure by replacing the
screws removed earlier in this step. Tighten
screws. Slide side burner control knob (O)
over valve stem.
13
O
P
Screws previously removed
O
14
P
Side burner
valve stem
T