Wiring - Craftmade Jamison JAM52 Guia De Instalacion

5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box and able to
support the fan, you are now ready to hang your fan. Grab the fan
firmly with two hands. Slide downrod through opening in hanging
bracket and let hanging ball rest on the hanging bracket. Turn the
hanging ball slot until it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball
with tab in hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the stepladder in
place and to help lift the fan up to you once you are set on the
ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be necessary to
use a heavy duty wood screw, washer and lock washer (not
supplied) with the safety cable loop. If necessary, adjust the loop
at the end of the safety cable. The loop at the end of the safety
cable should just fit over the threads on the wood screw. Test
safety cable by pulling on loose end of cable with pliers. If the
safety cable slips, the cable must be pulled tighter. Extra cable
slack can be left in ceiling area.

6. Wiring.

WARNING: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position.
CAUTION: Be sure outlet box is properly grounded and
that a ground (GREEN or Bare) wire is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the house/
building wires are different colors than those referred to in
the instructions, please use a qualified electrician.
Note: Excess lead wire length from the fan can be cut to
the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK and BLUE wires from fan to BLACK wire
from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together from fan
to BARE/GREEN wire from ceiling with wire connector
provided.
If you intend to control the fan light with a separate light
switch, connect BLUE wire from fan to the BLACK supply
from the independent switch.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
This fan is remote adaptable (remote control sold
separately).
white supply wire
black supply wire
from
ceiling
black
white
white
black
blue
from
fan
page 6
wood ceiling
joist
safety cable
loop
safety cable
hanging bracket tab
hanging ball slot
motor housing
ground
(green or bare)
wood screw
and washer
ground
(green
or bare)
*