Care And Maintenance; Troubleshooting - Kobalt SGY-AIR135TZ Manual Del Usuario

CARE AND MAINTENANCE

Always remove tool from air supply before performing any maintenance on tool.
An in-line oiler (not included) is recommended to be installed to air supply. It will help
increase tool life and keep the tool properly lubricated. The in-line oiler should be
regularly checked and filled with air tool oil as needed. To check if the in-line oiler is
properly lubricating the tool, place a sheet of paper next to the tool's exhaust ports
while holding the throttle completely open for 30 seconds. The in line oiler is properly
set when a light stain of oil collects on the paper. Excessive amounts of oil should be
avoided. In the event that it becomes necessary to store the tool for an extended
period of time, the tool should receive a generous amount of lubrication right before
being stored. After being well lubricated, the tool should be run for approximately 30
seconds to ensure oil has been evenly distributed throughout the tool. The tool should
be stored in a clean and wet dry environment away from the reach of children.
Recommended lubricants: Use air-tool oil or any other high grade turbine oil
containing moisture absorbent, rust inhibitors, metal wetting agent and an EP
(extreme pressure) additive. Consult your local retailer for further assistance
in selecting which air tool oil is best suited for proper lubrication.
STORING:
Tool must be well cleaned and lightly lubricated before storing.
Store air tool in a dry safe place, out of the reach of children.

TROUBLESHOOTING

PROBLEM
1. Grit or gum in tool.
2. No oil in tool.
3. Low air pressure.
Tool runs
4. Air hose leaks.
slowly or will
not operate
5. Pressure drops.
POSSIBLE CAUSE CORRECTIVE ACTION
1. Flush the tool with air-tool oil or gum
solvent.
2. Lubricate the tool.
3. a. Adjust the regulator on the tool to
maximum setting.
b. Adjust the compressor regulator to tool
maximum of 90 PSI.
4. Tighten and seal hose fittings if leaks are
found. Use sealing tape.
5. a. Be sure the hose is the proper size.
Long hose or tools using large volumes
of air may require a hose with an I.D. of
1/2 in. or larger depending on the total
length of the hoses.
b. Do not use a multiple number of hoses
with quick-connect fittings. This causes
additional pressure drop and reduces the
tool power. Always directly connect the
hoses together.
13
kobalttools.com