EAS ELECTRIC EMD09X2-V1 Manual De Instrucciones página 85

Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the
water, which would have a detrimental or adverse effect on the operation
of the appliance. The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in
your area. Your local Water Authority can advise you on the hardness of
the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt
consumed based on the hardness of the water used. This is intended to
optimise and customise the level o f salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Switch on the appliance;
2.Press the Program button for more than 5 seconds to start the water
softener set model within 60seconds after the appliance was switched
on;
3.Press the Program button to select the proper set according to your
local environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the set up model.
WATER HARDNESS
German French
ºClarke
ºdH
ºfH
0 - 5 0 - 9
6 - 11 10 - 20
15 - 21
12 - 17 21 - 30
22 - 28
18 - 22 31 - 40
29 - 42
23 - 34 41 - 60
43 - 69
35 - 55 61 - 98
1. ºdH =. 1,25 ºClarke = 1,78ºfH = 0,178 mmol/l
Factory setting: H3
1) Every cycle with a regeneration operation consumes additional 2.0
litres of water, the energy consumption increases by 0.02 kWh and
the program extends by 4 minutes.
British
Mmol/l
0 - 6 0 - 0.94
7 - 14
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.0
6.1 - 9.8
Water softener
level
H1: Rapid Light
H2: 90 Min Light
H3: Rapid, 90 Min Light
H4: ECO Light
H5: ECO, Rapid Light
H6: ECO, 90 Min
Light
36
Regeneration
occurs every
X program
sequence 1)
No regeneration
10
5
3
2
1
Salt
consumption
(gram/cycle)
0
9
12
20
30
60
V.2