Using Needle Threader - Brother PS-2470 Manual De Instrucciones

1
2
3
2
4
5
41
(Model PS-2470, PS-2360, PS-3100)
Turn power switch to "O".
1. Lower the presser foot lever.
2. Turn the balance wheel toward you (counter-clockwise) to raise
CAUTION
When using the needle threader, be sure the needle holder is
in the highest position. Otherwise, the hook may be damaged.
1
3. While lowering the needle threader lever, hook the thread onto
4. Pull down the needle threader lever as much as possible, then
• Hold the thread in front of the needle in order to make sure that
5. While lightly holding the thread, rotate the needle threader lever
6. Raise the needle threader lever and pull out about 5 cm (2") of
6
5
The needle threader can only be used with home sewing
machine needles size 75/11-100/16. Check the table on
page 47 for appropriate needle and thread combinations.
Note that, if you are using transparent nylon mono-filament
thread, only needles in the range of 90/14-100/16 can be
used.
The needle threader can not be used to thread the needle
when you are using decorative threads or specialty needles
like the twin needle and wing needle. When using those
types of threads or needles, thread the eye of the needle
manually. Make sure the main power switch is OFF when
threading the needle manually.

Using Needle Threader

the needle holder to the highest position.
1 Needle holder
2 Needle threader lever
the guide.
rotate the lever toward the back of the machine (away from you).
Make sure that the hook passes through the eye of the needle
and grabs the thread.
the hook grabs it.
1 Needle holder
2 Needle threader lever
3 Guide
4 Hook holder
toward the front of the machine (toward you). The hook will pull
the thread through the needle.
5 Hook
6 Thread
thread through the needle toward the back of the sewing
machine.
CAUTION
CAUTION