How To Stop Your Pressure Washer - Troy-Bilt 020242 Instrucciones De Uso

Section 4: Operation
9.
Start engine according to ins[ruc[ions given in engine
owner's manual.Also see opera[ing instruc[ions tag
Ioca[ed on [he pressure washer.
WARNING
When starting engine, pull cord slowty until resistance is felt
and then pull rapidly to avoid kickback.
If engine s_rts and fails to continue to run or if increased
resistance is fen during starting pull attempts, squeeze trigger
on spray gun.
NOTE: Always keep the throttle lever in the "Fast"
_osition when operating the pressure washer.
WARNING
DO NOT touch hot surfaces,
Allow equipment to coot before touching.
The pressure washer must be at least 5 feet from structures
having combustible wails and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of pressure
washer for" adequate cooling, maintenance and servicing.
Reflective exhaust heat may damage fuel tank causing fire.
Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark attester, maintained in
effective working order, complying to USDA Forest service
standard 5100-IC or later revision. In the State of California a
spark attester is required under section 4442 of the California
Public resources code. Other states may have similar laws,
How to Stop Your Pressure Washer
I. Let engine idle for two minutes,
2. Turn engine off according to instructions given in
engine owner's manual.
3. Squeeze trigger on spray gun to relieve trapped
pressure in hose to avoid injury°
NOTE: A small amount of water will squirt out when
pressure is released.
]
WARNING
Keep high pressure hose connected to pump and spray gun
while system is pressurized.
Squeeze trigger on spray gun to relieve trapped pressure,
every time you stop engine. Engage trigger lock on spray gun.
4. Engage trigger lock on spray gun when not in use,
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your ProjectPro TM nozzles, spray gun and nozzle
extension.There is also a hook at the front of the
accessory tray to hold your
high
pressure hose.
blOTE:The extra hole in the tray is for storing a utility brush.
The extra clip in the tray is for storing a turbo nozzle.The
brush and turbo nozzle are NOT included with your pressure
washer.You can buy these items as optional accessories.
I. Place nozzle extension through hole on accessory tray,
as shown in
Figure
II.
2. Place spray gun through hole on accessory tray on
right side of unit (Figure I I).
NOTE:You may also use the hooks at_ched to the base
and handle to store your gun and nozzle extension, as
shown on page 5.
3. Hang high pressure hose on hook attached to
accessory tray on front of tray, as shown in Figure I I.