Troy-Bilt 020242 Instrucciones De Uso página 13

Section 4: Operation
Cleaning and Chemical
[MPORTANT: Use soaps designed specifically for
pressure washers_
Household
detergents could damage
the pump.
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
Damage to equipment resulting from failure to follow this
instruction will void warrant>;
To apply detergent follow these steps:
[. Review ProiectPro TMnozzle use.
2. Prepare detergent solution as required by
manufacturer.
3. Place small filter end of detergent siphoning tube into
detergent container.
l
• When inserting
the filter into a detergent
solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot mufflen
4. Hake sure black ProjectPro TM cleaning detergent
nozzle is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (Yellow, Orange or Red).
5. Hake sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump and start engine.
6. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upwar& using
Iong, even, overlapping strokes.
7. Allow detergent to soak in between 3-5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow detergent
to dry on (prevents streaking).
iMPORTANT:You must flush the chemical injection
system after each use by placing the filter into a bucket of
clean water, then run the pressure
washer
in low pressure
for 1o2 minutes.
Pressure Washer Ninsing
For Rinsing:
I. Apply trigger lock to spray gun.
2. Remove black cleaning detergent nozzle from nozzle
extension.
3. Select and install desired high pressure nozzle following
instructions "How
to Use ProjectPro TM Nozzle System".
4. Keep spray gun a safe distance from the area you plan
to spray.
WANNING
Keep spray nozzle between 8 to 24 inches away from cleaning
surface:
Operate this unit on a stable surface_
Be extremely careful if you must use the pressure w,asher from
a ladden scaffolding or an>, other relatively unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back,
S. Apply a high pressure
spray to a small area and then
check the surface for damage. If no damage is found,
you can assume it is okay to continue rinsing.
6. Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
2.
3.
4.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine.
I. Place chemical injection siphon/filter in a bucket full of
clean water.
Attach black cleaning detergent nozzle.
Flush for I-2 minutes.
IMPORTANT: Simply shutting OFF engine will not
release pressure in the system. When the engine has
shut down, squeeze the trigger
on the spray gun to
relieve the pressure in the hose.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3°5 minutes
without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°EThe system engages to cool the pump by
discharging the warm water onto the ground.