Care And Maintenance - Homewerks 10-B82-WCH-B Manual De Instrucciones

ASSEMBLY INSTRUCTIONS
9. Put PTFE pipe tape or thread
sealant on both threaded ends
of the pipe nipple (1). Use a pipe
nipple that will project 3-7/8"
to 4" from the finished wall. Screw
the pipe nipple into the elbow (2)
inside the wall and tighten with a
pipe wrench. Screw the tub spout
(3) on until it is positioned and
flush to the finished wall.
TROUBLESHOOTING
PROBLEM: Leaks from spout
CAUSE: Damaged or dirty valve seat.
ACTION:
Remove faucet handle, cartridge, housing and valve spool to check the rubber
valve seal. Clean it or replace by calling Customer Service

CARE AND MAINTENANCE

Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and void your warranty.
ROUGH-IN
www.homewerksww.com
9
1
2
2 3/4"
11 1/8"
8"
2 1/2"
10. HANDLE INSTALLATON:
A. After finishing the wall
surface, slide flanges (10A)
onto valves and fit flush
against the finished wall.
B. Install the handle assemblies
(10B) as shown.
3
PROBLEM: Leaks from under handle
CAUSE: Bonnet is loose or bottom gasket on cartridge is dirty or twisted.
ACTION:
Remove faucet handle. Tighten the bonnet. Clean or replace O-ring.
1/2"−14NPT
6 1/2"
1/2"−14NPT
3
10
10B
10"
5 3/8"
10A