TECshow NAVIGATOR SPLIT 8 Manual De Usuario página 8

The transformation of the controller line of 3 pins and 5 pins (plug and socket)
5-Pins canon (socket)
Pin 1: GND (screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
Pin 4: N/C
Pin 5: N/C
3-Pins canon (socket)
Pin 1: GND (screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
socket to the first Navigator Split 8 "in" socket.
Connect another DMX signal cable from the first
Navigator Split 8 DMX "out" socket to the first
unit's "in" socket. Repeat this process to link
the second, third, and fourth units.
5. Supply electric power: Plug electric mains
power cords into each unit's IEC socket, then
plug the other end of the mains power cord into
proper electric power supply sockets, starting
with the first unit. Do not supply power before
the whole system is set up and connected
properly.
P. 8
Tecshow Navigator Split 8 | English version
1. Ground
2. Signal (-)
3. Signal (+)
1. Ground
2. Signal (-)
3. Signal (+)
3-Pins canon (plug)
Pin 1: GND (screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
5-Pins canon (plug)
Pin 1: GND (screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
Pin 4: N/C
Pin 5: N/C