Disposal; Troubleshooting; Technical Specifications - Beurer IH 26 Kids Instrucciones De Uso

• The accessories can be stowed securely in the
accessory compartment. Store the device in a dry
place, ideally in the original packaging.

9. Disposal

For environmental reasons, do not dispose of the de-
vice in the household waste.
Please dispose of the device in accordance wi-
th EC Directive – WEEE (Waste Electrical and
Electronic Equipment).
If you have any questions, please contact the
local authorities responsible for waste disposal.

10. Troubleshooting

Problem/ Possible cause/remedy
question
The atomiser 1. Too much or too little medication
produces no in the atomiser.
or too little Minimum: 2 ml,
aerosol. Maximum: 8 ml.
2. Check nozzle for blockages.
Clean nozzle if necessary (e.g.
by rinsing out). Then start using
the atomiser again.
IMPORTANT: Carefully pierce
the fine holes from the underside
of the nozzle only.
3. Atomiser not held vertically.
The atomiser 4. Unsuitable medication fluid
produces no added for nebulisation (e.g. too
or too little viscous).
aerosol. The medication fluid should be
prescribed by the doctor.
The output is Kinked hose, clogged filter, too
too low. much inhalation solution.
What medi- Please consult your doctor in
cations are relation to this matter. As a rule,
suitable for all medication that is suitable and
inhaling? approved for device inhalation can
be inhaled.
There is inha- This is normal and is due to
lation solution technical reasons. Stop inhalation
residue in the once the atomiser starts to make a
atomiser. notably different sound.
1. On infants and children, the
What should
be taken into mask should cover the mouth
account when and nose to ensure effective
using the inhalation.
device with
infants and
children?
Problem/ Possible cause/remedy
question
2. On children, the mask should
also cover both the nose and
mouth. It is not very useful to
carry out nebulisation next to
someone who is sleeping, as
in this case not enough of the
medication will reach the lungs.
Note: Inhalation should only be
carried out under the supervision
of an adult and with their assi-
stance and the child should not be
left alone.
Why should There are two reasons for this:
the atomiser 1. To ensure a therapeutically
be replaced effective particle spectrum, the
regularly? nozzle hole must not exceed a
specific diameter. Due to me-
chanical and thermal stresses,
the plastic is subject to a certain
degree of wear. The atomiser
insert [9] is particularly sensitive.
This can also alter the compo-
sition of the aerosol droplets,
which directly affects the effec-
tiveness of the treatment.
2. Regularly changing the atomiser
is also recommended for hygie-
ne reasons.
Should each Yes, this is absolutely essential for
person have hygiene reasons.
their own
atomiser?

11. Technical specifications

Model IH 26 Kids
Type IH 25/2
Dimensions
(W x H x D) 166 x 141 x 148 mm
Weight
1.4 kg
Operating
pressure approx. 0.8 to 1.45 bar
Atomiser filling Min. 2 ml
volume Max. 8 ml
Medication flow
rate approx. 0.3 ml/min
Nasal douche Min. 2 ml
filling volume Max. 10 ml
Sound pressure approx. 52 dBA
(acc. to DIN EN 13544-1 section 26)
22