Publicidad
Idiomas disponibles
Idiomas disponibles
35 (RH)
20
5a.
Lay out rails #25 and 26, as shown in Figure 3, around edges
of table top.
5b.
Slide Left #36 and Right #35 Vinyl End Caps onto the ends of
the Side Rails #25 as shown.
6.
Line up holes in rails with pilot holes in top and secure using
eighteen screws #20. See Figure 3.
7.
Lay Corner Caps #22 on table as shown in Figure 4. If Corner
Cap sticks above table top surface of table, flip over so shorter
distance is against edge. Secure to bottom of table with three
screws #21.
8.
Rotate U-support #7 until you see the screw hole in
the slot of U-clip #3. Slide U-support #7 side to side
if necessary.
Note: To aid in assembly you can use a cordless drill and
Phillips bit for Step 9 only. Wear safety glasses.
9.
Insert screw #19 through slot in U-clip #3 and into
U-support #7. Thread it all the way into U-support
#7 until it touches the back of the tube. There should
be about 3/8 inch of screw #19 left sticking out. Re-
peat for U Leg #2 and U-clip #34.
If you want to see a video on how to insert Screw (#19) go to:
http://www.escaladesports.com/customer-service/videos.html
Figure 4
Note: Slide U-Support back and forth until
you see the hole (if necessary).
Figure 5
3
34
3
This end is the
middle of the table
Figure 3
Publicidad
