Husqvarna K 7000 Manual Del Usuario página 23

material to be cut. This decreases the temperature of
the blade and is an effective way to cut.
Basic working techniques with K 7000
SmartGuard
WARNING:
is disengaged if the SmartGuard is manually
retracted. Only retract the SmartGuard
manually if you must and there are no risks
of kickback.
SmartGuard gives more coverage of the blade. This
decreases the risk that you touch the blade if a kickback
occurs.
• You can retract the SmartGuard manually with the
SmartGuard handle.
• Hold the SmartGuard handle with a left hand finger
while the remaining fingers hold the front handle at
the same time.
To do a check of the RCD 3 phase
1. Start the product, refer to
page 24 .
1635 - 003 - 20.08.2021
The SmartGuard function
To start the product on
2. Look into the inspection holes and push the RCD
test button.
3. Make sure that the RCD moves and that it
disconnects the product from the power supply.
4. Turn the RCD reset knob to reset the RCD.
To connect the water supply
CAUTION:
operate the product. The temperature of the
product is decreased by water also during
dry cutting.
CAUTION:
to keep the diamond blade core and
segments cool when you cut. Diamond
blades for wet cutting cannot be used dry.
1. Connect the water hose to the water supply. Refer to
# for the lowest permitted water flow.
Note:
The hose nipple of the product has a filter.
Always use water when you
Use correct water pressure
23