Cleaning And Maintenance; Scope Of Delivery - HSM 411.2 Instrucciones De Servicio

https://www.supplychimp.com

6 Cleaning and maintenance

Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
must enter the equipment.
Check that the door switch is working properly:
Warning!
If the following procedure cannot be
performed, switch off the document
shredder, disconnect the mains plug
and contact customer service.
• Insert the mains plug and switch on the
shredder.
• Feed in a sheet of paper and open the front
door while the paper is being drawn in.
The cutting unit must turn off immediately
and the "door open" indicator must light up.
• Close the door.
The cutting unit must not yet restart.
• Pull the paper out of the feed opening. The
light barrier must be clear.
• Switch off the machine and then switch back
on.
The cutting unit starts when paper is fed in.
• Spray special cutting block oil
through paper feed opening across
the whole width of the cutting system
blades.
• Run cutting system forwards and
backwards several times without
feeding paper.
Paper dust and particles are shaken
off.
0802
Oil the cutting unit when
cutting performance de-
creases or the device be-
comes noisy, or every time
you empty the waste con-
tainer:
HSM 411.2

7 Scope of delivery

• Paper shredder, ready for connection, in car-
ton packing, carton on pallet, tied with strap-
ping tape
• 5 bags for shredded material
• Special cutting block oil
• Operating instructions
Acces so ries
• Bag for shredded material,
order No.: 1.442.995.000
• Special cutting block oil 250 ml,
order No.: 1.235.997.403
13