Bimar S340.EU Folleto De Instrucciones página 7

Fax +32 030 9904733

they understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.
•
A
ttention: when using electric appliances, the basic safety precautions must always be
observed to avoid risks of fire, electric shocks and physical injury.
•
U
nplug the appliance when not in use.
•
T
he fireguard of this heater is intended to prevent direct access to heating elements and must
be in place when the heater is in use, but the fireguard does not give full protection for young
children and for infirm person.
•
D
o not move the appliance when it is in function.
•
T
hat the user must not leave the appliance unattended while it is connected to the supply.
•
D
o not touch the heater with wet hands or feet.
•
N
ever use the fan heater to dry damp garments.
•
D
o not expose the heater to the weather (sun, rain, etc.).
•
D
o not pull on the power cord or the appliance to unplug the appliance from the wall socket.
Never move the appliance by pulling the cord.
•
I
f the electric cord is damaged, it has to be replaced by the supplier or an authorized service center
or a professionally qualified, to avoid any risks.
INSTALLATION
• After removing the packing materials, check the integrity of the heater; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity (230V~ 50Hz) and that the electric plug is grounded. In the event of incompatibility
between the electric outlet and the plug of the heater, have the outlet replaced with another more
suitable type by professionally qualified personnel, who will make sure that the section of the wires
of the outlet is appropriate for the absorbed power of the heater (10A). Check that the mains are not
connected equipment; high absorption to prevent overloading and fire risks. In general, the use of
adapters or extension cords is not recommended; if their use is indispensable, they must conform to
existing safety standards and their current capacity (amperes) must not be less that the maximum of
the heater.
Attention: before use the appliance remove the detachable coupon to stick the handle.
• Before each use, verify that the heater is in good condition and that the electrical cord is not
damaged: in the case of doubt, ask for professionally qualified help.
• Make sure that the cable is correctly positioned and that it is not in contact with hot parts or sharp
edges, nor wrapped around the device or twisted.
• The appliance must not be positioned immediately under a socket.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Position the fan heater far from other sources of heat, inflammable materials (curtains, carpets,
etc.), inflammable gases or explosive materials (spray cans) and from materials that can deform on
exposure to heat. Make sure that there is 100 cm of free space in front of the fan heater and 30 cm
on the sides. Do not use the heater in the immediate vicinity of a bathtub, shower or swimming
pool (to avoid drops of water falling on the heater or the heater falling in the water), or in places
where it could be subject to shocks.
• Do not hang or simply pull the unit to the wall or walls.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
7 24
/
Assembly page 7/24