Omnitronic DSS-2 Manual Del Usuario página 30

6.8 Auto-Cue function:
After switching on or after pressing the Track-buttons, the player automatically jumps to the section where
the music starts. This fuction enable to minimize the transitions between two tracks.
Back-Cue function:
If you press the Cue-button during playback, the player returns the position where the playback started and
goes into Pause-mode. Please note that this function is only available within one track.
Bop-function:
When calling the Cue-point via the Reloop-button the player remains in the play-mode.
Memorizing the Cue-point:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode and the Cue-button flashes.
Select the Cue-point via the Scratch-wheel. The display shows the selected starting-point (e.g. 3:42 22).
Press the Cue-button in order to memorize the Cue-point. The Cue-button is permanently lit. Start the
playback via the Play/Pause-button or the Bop-button.
6.9 Memorizing a sequence (Loop-function)
With the Loop-function, you can repeat a programmable sequence.
Memorizing the Loop-points:
Possibility 1:
The player is in Playback-mode.
If the In-button is pressed in the playback-mode, the CD keeps running and the A-point (starting-point) is
marked. If the Out-button is pressed once more, the B-point (end-point) of the sequence is marked.
The player repeats the sequence between A-point and B-point until you press the Exit-button.
Possibility 2:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
Select the A-point (starting-point) via the Scratch-wheel. The display shows the selected A-point (e.g. 3:42
22). Press the In-button and the selected A-point is marked.
Select the B-point (end-point) via the Scratch-wheel. The display shows the selected B-point (e.g. 3:51 11).
Press the Out-button and the selected B-point is marked.
The player repeats the sequence between A-point and B-point until you press the Exit-button.
You can repeat the sequence once more if you press the Reloop-button.
6.10 Relay-operation
In the Relay-operation, the device automatically switches to the other player after playback has stopped. In
this way, you have the possibility to enlarge the music program by using several CDs. In the Single-mode,
on track is played and then the CD is changed, in Continuous-mode, CD1 is completeley played and then
CD2.
Press the Relay-button (LED on).
Start playback of CD1. As soon as the current track of CD1 is finished, the player automatically starts CD2.
The first CD-player goes into Pause-mode. You can enter a new CD or memorize a Cue-point at the
respective player in the Pause-Mode.
6.11 Phone/Line/CD-Switch
Used to select the input to be sent to the individual channel.
6.12 Gain-Control
Used to set the level of the input signal.
30/64 10553155_V_1_0.DOC