Echo SRM-280 Manual Del Operador página 2

2
I
NSTALLATION
Tools Required: 8mm x 10mm Open End Wrench, T-wrench
1. Close choke and remove air filter and cover.
2. Disconnect ignition stop leads (A) and (B).
3. Loosen nut (C) and remove throttle linkage from carburetor
bracket.
4. Remove inner throttle linkage from carburetor swivel (D).
5. Loosen the two (2) drive shaft clamp bolts (E) at engine drive
shaft clamp, and remove center drive shaft location bolt (F).
6. Pull drive shaft assembly from clutch case.
7. Loosen two (2) rear handle screws (G) and pull rear handle from
the drive shaft assembly.
8. Loosen two (2) screws (H) and remove front handle.
INSTALLATION INSTRUCTIONS U-HANDLE KIT
A
B
B
E
E
F
H
A
D
C
G