Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT INSTRUCTIONS:
PLEASE READ AND SAVE THESE IMPORTANT SAFEGUARDS
Thank you for choosing an Optimus heater. To ensure the best performance from your heater,
please read and save the following instructions.
WHEN USING ELECTRICAL APPLIANCES, BASIC PRECUATIONS SHOULD ALWAYS BE
FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO
PERSON, INCLUDING THE FOLLOWING:
Read all instructions before using this heater.
●
This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use grip
●
handle when provided.
Keep combustible materials such as drapes, furniture, pillows, bedding, papers, clothes, and
●
curtains at least three (3) feet (0.9m) from the front of heater and keep them at least 1 foot (0.3m)
the sides and rear of the heater.
Extreme caution is necessary when heater is used by or near children or invalids and whenever
●
the heater is left operating and unattended.
Always unplug heater when not in use.
●
Do not use any heater with a damaged cord or plug or after the heater malfunctions or has been
●
dropped or damaged in any manner. Return heater to manufacturer for examination, electrical
or mechanical adjustment, or repair. (See Warranty for information).
Do not use outdoors.
●
This heater is not to be used in bathrooms, laundry areas or other similar indoor locations.
●
Never locate heater where it may fall into a bathtub or other water container.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange
●
cord away from traffic area where it will not be tripped over.
To disconnect heater, turn control to OFF then remove plug from outlet.
●
●
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may
cause electric shock or fire or damage the heater.
To prevent possible fire, do not block air intakes or exhaust in any manner. Do not use on soft
●
surfaces, like a bed, where openings may become blocked.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint
●
or flammable liquids are used or stored.
Use this heater only as directed in this manual. Any other use not recommended by the
●
manufacturer may cause fire, electric shock or injury to persons.
Avoid the use of an extension cord because the extension cord may overheat and cause risk of
●
fire. However, if you must use an extension cord, the cord shall be No. 14AWG minimum size
and rated not less than 1875 watts. Never use a single extension cord to operate more than one
Heater.
If the heater will not operate: See specific instructions in Safety Feature explained in this
●
manual.
CLEANING/ MAINTENANCE INSTRUCTIONS:
During Season Care:
Before cleaning, be sure to turn off and unplug the heater.
•
Carefully wipe the unit with a soft, damp cloth. Please be very cautious near the motor and
•
heating elements.
Do not immerse the heater in water.
•
Never use gasoline, benzene or thinner. This will damage the surface of the heater.
•
After cleaning, be sure to completely dry the unit with a cloth or towel.
•
After Season Care:
Store heater in a cool and dry location with power cord properly secured.
•
Please store the unit in its original carton or suitable container.
•
OPERATING INSTRUCTIONS:
PRE-OPERATING INSTRUCTIONS:
Carefully remove your heater from the box (please save the carton for off-season storage).
•
Make sure the unit is in the OFF position before plugging the heater into the outlet.
•
Place heater on a firm level surface.
•
OPERATING INSTRUCTIONS:
Plug the power cord into a wall outlet (110-120V AC, 60Hz).
•
Turn the Selector-Control Knob to desired heat setting(LOW for 750W or HI for 1500W)
•
For fan-only operation,without any heat output,turn the selector control to the FAN setting.
•
When the unit is turned on the power indicator light will illuminate to tell you that the heater is
•
functioning.
THERMOSTAT INSTRUCTIONS:
Before setting the thermostat,allow the heater to operate and warm up the room.You need to
•
set thermostat on Hi to start the heater.
When the desired temperature/comfort level is reached,lower the thermostat setting until the
•
fan/heater stops operating.
Turning the knob clockwise will increase the temperature setting.
•
The control will now automatically maintain the pre-set temperature level by turning the heater
•
ON and OFF.
Note:It is normal for the heater to cycle ON and OFF as it maintains the preset temperature.To
prevent the unit from cycling,you need to change to change the thermostat setting.
AUTOMATIC OVERHEAT SAFETY CONTROL DEVICE:
This heater is equipped with a patented,technologically-advanced safety internal heat limiting
thermostat and overheat protection circuit. When a potential overheat temperature is reached,
the system will automatically shut the heater off.
SERVICE INSTRUCTIONS:
Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing
•
so will void the warranty.
•
If you have any questions regarding this unit's operation or believe any repair is necessary,
•
please call 1-888-672-5832 to speak with a Customer Service Representative.
If you need to exchange the unit, please return it, in its original carton with a sales receipt
•
enclosed, to the store you purchased it. If you are returning the unit more than 30 days after the
date of purchase, please see the enclosed warranty.
If you have any other question or comments, feel free to write us:
•
Optimus Enterprise, Inc.
2201 E. Winston Road, Unit J
Anaheim, CA 92806
E-mail: Service.Optimus@gmail.com
Publicidad
