Accessories; Selection And Mounting Of The Cleaning Pads And Tips - Walter SURFOX 104 Manual De Usuario

10

Accessories

Accessories
A) Selection and mounting
of the cleaning pads and tips
Tungsten tips are made from high quality tungsten alloy
material. Other materials will not resist the harsh environ-
ment created by the electrochemical process.
WARNING! When the insert is too worn, it can
cause damage to the cleaning pads.
In this example of a worn insert, there are only two
contact points. All the current comes out of these
two points. Because of the lower available cross
section, the temperature will be higher at the two
points and the cleaning pads may become dam-
aged or wear out prematurely.
Inserts
Tungsten insert 90°
No: 48-R 133
Use with cleaning pad 54-B 026 or 54-B 040 and clamp
ring 54-B 002 or boot 54-B 005.
12
TIP! Resurface the insert using a bench grinding wheel or
Note: Be sure to install the O-Ring located at the back of
the insert whenever they are changed.
O-Ring
angle grinder.
Narrow tungsten insert 90°
No: 54-B 017
Use with cleaning pad 54-B 028 or 54-B 041 and
clamp ring 54-B 020 or boot 54-B 007.
Narrow tungsten insert 60°
No: 54-B 018
Use with cleaning pad 54-B 028 and clamp ring
54-B 020 or boot 54-B 008.