Overheating Protection - TESY HL-200H Manual De Instrucciones

•
You must never place the appliance below socket
outlets!
•
The appliance is not suitable to be used in a
bathroom.
MAINTENANCE
•
Summer mode (fan only): Turn the switch
clockwise to position
•
Heating at low power: Turn the switch clockwise
to position "I".
•
Heating at high power: Turn the switch clockwise
to position "II".
•
Temperature regulation: When the desired room
temperature is reached, turn the switch slowly
clockwise after position "II" until you hear a click.
The set temperature is managed and maintained
automatically via the thermostat.
•
Switch off: Turn the switch clockwise to position "0".
•
Freezing preventing function: When the
thermostat is at position
minimum room temperature of about 5
consumption of power.
CLEANING
•
You must first turn off the appliance and disconnect
its plug from the socket. Do not use abrasive
detergents!
•
Clean the body with wet cloth, vacuum cleaner or
a brush!
•
You must never submerge the appliance under
water – there is life danger!
•
If the appliance should not be used for a certain
period of time it must be secured from excessive
dirt and dust by placing it in its original package.
•
You must never place the hot appliance in its
package!
English
.
, the device sustains
о C at limited
WARNING
•
Do not use the appliance next to shower, bath,
shower room, swimming-pool etc.
•
The appliance always should be used in upright
position.
•
Do not use the fan heater for laundry drying. Never
cover the inlet and outlet grating (there is a risk
of overheating). The appliance must be placed at
a distance of minimum 50 cm from furniture and
other objects.
•
The appliance must be placed so that its control
switches are not in the hand-range of persons using
bath or shower.
•
Do not use the appliance in rooms smaller than 4
square meters.

OVERHEATING PROTECTION

The in-built overheating protection automatically turns
the appliance off in case of an error! In that situation
the plug must be disconnected from the mains and the
control switch put in position "0". After a short period of
cooling the appliance is ready for operation (in about
10-15 minutes)! If that error is repeated – consult an
authorized service at your location!
Warning: in order to avoid
overheating do not cover the appliance!
Instructions for environment protection
Electric appliances out of use contain valuable
materials and hence must not be disposed in
domestic dumbs! We kindly ask you for cooperation
and active role in preservation of natural resources by
disposing the appliance to the organized buy-back
locations ( if there are any).
Usage and Storage Instructions
EN
5