Blade Assembly; Light Kit Assembly (Optional). Pgs - Craftmade Enduro END52 Guia De Instalacion

9. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in one of the hardware packs. Hold blade arm up
to blade and align holes. (Be sure to install blades
with ridged-side facing up and flat side facing the
floor). Insert 3 blade attachment screws (along
with washers) with fingers first and then tighten
screws securely with a Phillips screwdriver. Repeat
procedure for remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock
washers to secure blade arms). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat this
procedure with remaining blade arms. Securely
tighten all screws.
Note: Tighten blade arm screws twice a year.
10. Light Kit Assembly (Optional).
If you wish to use fan WITHOUT the light kit,
please proceed to Section 11 on page 8 to complete
installation.
If you wish to use fan WITH the light kit:
Remove 3 screws from switch housing cap and
remove switch housing cap from switch housing.
Punch center cap out of switch housing cap with a
screwdriver.
IMPORTANT: Any light kit purchased for use with this
fan MUST be UL-APPROVED for WET LOCATIONS or
OUTDOOR USE.
Locate BLUE (or BLACK) and WHITE wires in switch
housing labeled FOR LIGHT KIT CONNECTION.
Remove and discard plastic that holds these 2 wires
together.
Locate hex nut and lock washer in hardware pack.
Push wires from light kit fitter through center hole
in switch housing cap and then screw switch
housing cap onto threaded rod.
["Light Kit Assembly" continued on next page.]
plastic
motor
lock
lock washers
blue (or black) wire
center cap
hex nut
lock washer
page 7
motor housing
blade arm
blade arm
screws
motor housing
white wire
switch housing
switch
housing
cap
switch housing cap
light kit fitter
blade