Threading The Needle (Using The Needle Threader) - Brother 884-B01 Manual De Instrucciones

Threading the needle
(using the needle threader)
The needle can be threaded by one-touch
operation using the needle threader.
1. Lower the presser foot lever 1 to lower the
presser foot.
1
2. Pull the end of the thread, which has been
passed through the needle bar thread guide
2, to the left, then pass the thread through the
notch of the thread guide 3, and then firmly
pull the thread from the front and insert it into
the slit of the thread guide disk 4 all the way.
NOTE:
Make sure that the thread passes the notch of the
thread guide 3 .
3. Cut the thread with the thread cutter 5 on the
left side of the machine.
5
18
2
4
3
4. Lower the needle threader lever 6 on the left
side of the machine as much as possible.
6
The thread passes through the eye of the
needle.
5. Release the needle threader lever 6.
6. Carefully pull the loop of the thread through the
eye of the needle to pull out the end of the
thread.
7. Raise the presser foot lever 1, then pass the
end of the thread through the presser foot, and
then pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
5cm