Inserting Batteries In The Remote Control; Connecting The Antenna; Connecting The Power Supply; Switching The Smart Tv On And Off - Medion LIFE X14360 Guía Rápida

3.3. Inserting batteries in the remote control

 Loose the screw of the battery compartment cover on the back of the remote control and
remove the cover.
 Insert two LR03 (AAA) 1.5 V batteries in the battery compartment of the remote control. Check
the battery polarity (inscribed on the bottom of the battery compartment).
 Close the battery compartment by fixing the cover with the screw.
NOTICE!
Risk of damage!
The remote control can be damaged by leaking batteries if not used for a long
period of time!
 Remove the batteries from the remote control if the device is not going to be
used for a long period.

3.4. Connecting the antenna

Your smart TV supports different antenna signals.
You can feed the following picture signals via the connection labelled ANT.
• via analogue cable/an analogue house antenna,
• via a DVB-T/ DVB-T 2
2
• via a DVB-C connector (digital cable)
 Connect the antenna cable from either the house aerial/the analogue cable connection, the
DVB-T antenna or the DVB-C connection to the antenna connection on the smart TV
You also have the option of connecting a digital satellite system to the connection labelled LNB.
 Screw the F connector of a coaxial antenna cable onto the connection on the smart TV.
To receive encrypted/subscription channels you will need to use a CI module and
an appropriate card. Insert a CI module (available in specialist shops) into the slot
provided for this purpose on the left-hand side of the device (Common Interface).
You can then insert the card from your provider into the CI module.

3.5. Connecting the power supply

 Connect the mains plug on the device to an easily accessible 220 - 240 V ~ 50 Hz mains socket.
3.6. Switching the smart TV on and off
 The device will be in standby mode as soon as you have connected the mains plug to the mains
socket.
 To switch on the device, press
− on the remote control: the Standby/On button , one of the number buttons or one of the
  buttons;
P /
− on the device: the multifunction button .
 Use the Standby/On button
mode. Although the device has been switched off, it will continue to consume electricity.
If the device is not receiving an input signal, it will automatically switch to standby
mode after five minutes. A countdown timer will appear on the screen until this
time. This function is not available for all sources
2
This service must be available in your region.
10
2 antenna or
on the remote control to switch the device back into standby
.