OSIP VC 50 Manual De Instrucciones página 4

Ditta costruttrice. Nel caso di manomissioni il diritto di garanzia
decade automaticamente.
La garanzia ha validità di 24 (ventiquattro) mesi dalla data di
acquisto e comprende la riparazione gratuita di difetti dovuti
ad un montaggio errato o all'impiego di materiali difettosi.
Sono esclusi dalla garanzia i materiali di usura come le tenute
meccaniche, i paraoli e le giranti.
Nel caso si richieda la garanzia è necessario esibire un
documento che certifichi la data d'acquisto (bolla di
consegna,fattura o scontrino fiscale).
QUESTO PRODOTTO E' CONFORME ALLE SEGUENTI
DIRETTIVE:
73/23/CEE Direttiva sulla bassa tensione
93/68/CEE Direttiva sulla marcatura CE
89/336/CEE Direttiva sulla conformità elettromagnetica
e omologato in base alla normativa: EN60335-2-41:1996
E N G L I S H
1. ASSUMPTION
 Please read these instructions carefully before use.
Damages resulting as consequence of instructions
disregards will not be covered by manufacturer's
warranty.
 Please pay particular attention to the chapter
relating the safety instructions.
 Save these instructions and refer to them anytime your
are in doubt.
2. APPLICATION
These submersible electric pumps are made mainly for the
applications listed below:
Made in Italy
- 4 -
Continuously rated
Water lift from 7 metres depth maximum (condition
normally referred at sea level)
Max liquid temperature operating 35°C
Suitable for closed circuit coolant systems
Domestic irrigation
Domestic pressure boosting
3. USE CONDITIONS
 Liquid temperature must not exceed 35° C.
 These pumps are suitable to be used in to chemically
neutral liquids.
 Do not pump hydrocarbons or any other
inflammable liquid.
 Pumping liquids containing sand or other abrasive
substances may reduce sensitively the life of the
pumps. In this case we recommend to assemble a
strainer at the suction.
 Never run pump dry. Dry runs may damage seals and
cause possible hazards of burns to persons handling
the pump.
4. SAFETY
Careless use of electric appliances is always
dangerous. Electric appliances used into water
represent a potential hazards of electric shock. Thus
we strongly recommend to pay full attention to the next
instructions. If you still have doubts, contact an expert
electrician or the manufacturer.
Eventual connection of a power cord must performed
by an expert electrician in accordance of the
regulations is use in your Country
HAZARD! Do not touch the plug with wet
hands! Switch off and unplug the pump before any
maintenance.
Do not cut or engrave the power cable.
Mains system must be provided of a residual current
device of max 30 mA capacity.
5. INSTALLATION
Installation may result to be fairly complicated therefore it
should be carried out by a skilled person.