Laundrylux Wascomat Encore WHLFP715M Manual De Instalación página 13

Siting
Install the machine close to a drain standpipe or
floor drain, and within 4 feet of the water supply
spigots. In order to make installation and servicing
the machine easier the following clearances are
recommended:
• At least 20 inches (500 mm) between the
Fig.
machine and the wall behind.
4
• Minimum 1 inch (25 mm) to next machine if
more than one machine is installed in a row.
Floor
• The floor must be smooth and hard. Do not
install the machine on carpet or other soft
material.
• The floor must hold the total weight of the
machine filled with water and a load. This
static weight is 416 pounds (188 kilograms).
• Adjust the leveling legs of the machine, as
needed, to ensure that it is level front to back,
and side to side, and so that all four feet are
in contact with the floor. After leveling the
machine, use the enclosed locknut wrench
tool to tighten each leg's locking nut against
the underside of the washer.
Installation
4
Water supply
2:3
Drain standpipe