RIDGID RT1800M0 Manual Del Usuario página 33

ASSEMBLY
Installing/Removing Cart Push
Handle
1. To Install Handle: Slide the Cart Push
Handle into the two Handle Holders
found on the rear of the Dust Drum.
2. Press down evenly on the Cart Push
Handle until both sides are fully seated
in the Handle Holders. The Release
Buttons should audibly snap into the
Locking Holes.
INSTALL:
SP7083 RT1800M0 SE 2019.indb 33
Cart Push Handle
Dust Drum
Release
Buttons (2)
Handle
Holders (2)
33
3. To Remove Handle: Grasp both
sides of the Handle just above the
Handle Holders. Press in firmly on the
two Release Buttons using the index
fingers while pulling up on the Cart
Push Handle. It may help to place a
foot on one of the rear feet to secure
the Vac.
REMOVE:
Cart Push Handle
Release
Buttons (2)
Handle
Holders (2)
1/9/19 12:52 PM