Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3. Mounting accessories
Make sure that the plug has been
removed from the plug socket during the
assembly of accessories.
Installation of the machine
•
Install the welding appliance in a dry and clean
space (free of iron powder, dust and paint).
•
Place the welding appliance on a firm and flat
surface and at least 20 cm from the wall.
•
Protect the welding appliance against rain and
strong sunlight.
The welding mask
Fig. 2
•
Assemble the welding mask by fixing the
handle with the delivered screws.
•
Place the light glass (protective glass) in front
of the dark welding glass. Place the glasses
inside the window and lock them.
•
Make sure that the glasses are positioned so
that no (harmful) light can now penetrate the
opening.
•
Replace the light protective glass when the
view of the workpiece becomes insufficient
during welding. Replacing the dark welding
glass is considerably more expensive than
replacing the light protective glass.
Fitting new electrodes
The electrode consists of a metal core enclosed
by a coating. At one end of the electrode the core
is not covered by the coating.
•
Press the handle of the electrode holder
against
the spring.
•
Place an electrode with uncoated end (± 2 cm)
in the electrode holder. Make sure that the
non-coated part makes good contact with the
metal part of the electrode holder (electrode
not pushed too far in the electrode holder).
•
Release the handle of the grip. The electrode
is now fixed.
N.B! Do not allow the electrode to burn to
lengths shorter than ± 5 cm because of
overheating and/or the deformation of the
electrode holder. The burnt up electrode
will then be difficult to remove.
6
All manuals and user guides at all-guides.com
Removing used electrodes
Press the grip of the electrode holder against the
spring so that the burnt up electrode can fall from
the holder.
Installation
Fig. 4
The initial positon of the switch (2) is set to "OFF".
The machine has 2 plugs, it can be used at 230V
or 400V voltage.
•
•
Please note the following to avoid the risk of
fire, electric shock or injury to persons:
1
2
3
4. Operating
Before use:
a. General information about electric arc welding
b. The electrode
c. Protective clothing
d. Face protection
e. Working environment
N.B! Do not remove the electrode from
the holder by hand. The electrode is very
hot!
N.B! Watch where the waste electrode
falls to prevent a fire hazard and possible
injury.
Warning: Read instruction manuals
before operating and servicing this
equipment.
With the VDE plug, it can only be used in 230V
postion. To opearate the welder at 230V
voltage,connect the VDE plug to 230V power
supply, then turn the switch (2) from "OFF" to
230V positon.
With the 5 pin industrial plug it can only be
used at 400V. Connect the industrial plug to
400V power supply, then turn the switch (2)
from "OFF" to 400V positon.
Please make sure before operating the welder
that the rated voltage of the unit matches that
of the power source.
Please disconnect the device from the power
supply before setting the nominal voltage.
Adjusting the nominal voltage during operation
of the welder is prohibited.
Ferm
Publicidad
