Troubleshooting - Craftsman 917.27394 Manual Del Usuario

Ocultar thumbs Ver también para 917.27394:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEM
Will not start
Hard to start
Engine will not
turn over
Engine clicks but
will not start
CAUSE
1
Out of fuel.
2
Engine not "CHOKED" properly.
3
Engine flooded.
4
Bad spark plug.
5
Dirty air filter.
6
Dirty fuel filter.
7
Water in fuel.
8
Loose or damaged wiring.
9
Engine valves out of adjustment.
1
Dirty air filter.
2
Bad spark plug.
3
Weak or dead battery.
4
Dirty fuel filter.
5
Stale or dirty fuel.
6
Loose or damaged wiring.
7
Engine valves out of adjustment.
1
Clutch/brake pedal not depressed. 1 Depress clutch/brake pedal.
2
Attachment clutch is engaged.
3
Weak or dead battery.
4
Blown fuse.
5
Corroded battery terminals.
6
Loose or damaged wiring.
7
Faulty ignition switch.
8
Faulty solenoid or starter.
9
Faulty operator presence
switch(es).
1
Weak or dead battery.
2
Corroded battery terminals.
3
Loose or damaged wiring.
4
Faulty solenoid or starter.
CORRECTION
1 Fill fuel tank.
2 See "TO START ENGINE" in
Operation section.
3 Wait several minutes before
attempting to start.
4 Replace spark plug.
5 Clean/replace air filter.
6 Replace fuel filter.
7 Empty fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel filter.
8 Check all wiring.
9 Contact a Sears or other qualified
service center.
1 Clean/replace air filter.
2 Replace spark plug.
3 Recharge or replace battery.
4 Replace fuel filter.
5 Empty fuel tank and refill tank with
fresh, clean gasoline.
6 Check all wiring.
7 Contact a Sears or other qualified
service center.
2 Disengage attachment clutch.
3 Recharge or replace battery.
4 Replace fuse.
5 Clean battery terminals.
6 Check all wiring.
7 Check/replace ignition switch.
8 Check/replace solenoid or starter.
9 Contact a Sears or other qualified
service center.
1 Recharge or replace battery.
2 Clean battery terminals.
3 Check all wiring.
4 Check/replace solenoid or starter.
33

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido