Tripp-Lite PS Serie El Manual Del Propietario página 2

Important Safety Instructions
SAVE THESE INSTRUCTIONS
• DO NOT connect the power strip to an ungrounded outlet.
• DO NOT use the power strip with 2-wire extension cords or adapters.
• This power strip is designed for indoor use only. Install the power strip away from heat-emitting
appliances such as radiators or heat registers.
• Do not install where excessive moisture is present.
• Do not plug extension cords into the power strip.
• Never install electrical, telephone, network or coaxial wiring during a lightning storm.
• Do not drill into any part of the housing or open the housing for any reason. There are no
user-serviceable parts inside.
Equipment Connection
Plug your equipment into the Power Strip's AC receptacles. DO NOT plug in equipment that draws
more total amps than your Power Strip's amperage rating (see label on Power Strip for amperage
rating), or you will trip the circuit breaker. If the circuit breaker trips, remove overload and depress
breaker to reset. Leave enough clearance at the end of the Power Strip to allow the circuit
breaker to operate normally.
Note: Select models with a power switch feature a protective switch cover. To access the switch, flip open the
attached cover.
Wall Mounting
All Power Strip models feature clips for horizontal or vertical mounting on a variety of surfaces.
The user must supply other mounting hardware (screws, etc.) and determine its suitability for use
with the chosen mounting surface.
1
Mark a straight horizontal or vertical line where
you want to mount the Power Strip. At each end
of the line, mark where the edges of the Power
Strip will be located. Place a mounting clip on
the mounting surface 1" (2.54 cm) in from
these edges and mark where the screws must
be driven into the wall. For strips longer than
48" (120 cm), also mark a screw hole for a third
mounting clip midway between the other two.
2
Keyhole Mounting: Drive #8 screws directly
into the mounting surface. Snap the mounting
clips onto the Power Strip
Power Strip on the screws by the keyhole slots
on its mounting clips
15-02-180-933408.indb 2
2a , then hang the
2b .
2
1
2a
2b
2/18/2015 10:41:58 AM