Cafe C2S950M Manual Del Propietário página 29

Troubleshooting tips ... Before you schedule service
Problem
Oven light does not
work
Oven will not self-clean
Excessive smoking
during clean cycle
Oven not clean after a
clean cycle
Strong "burning" or
"oily" odor emitting
from the vent
Excessive smoking
during broiling
Oven door will not open
after a clean cycle
"F— and a number or
letter" are displayed on
LCD screen
Power outage, clock
resets
Lock Control feature is
activated
Burners do not light
28
Possible Cause
Light bulb is loose or defective.
The temperature is too high to set a
self-clean operation.
Oven controls improperly set.
Excessive soil or grease.
Oven controls improperly set.
Oven was heavily soiled.
This is normal in a new oven and will
disappear in time.
Food too close to burner element.
The oven door is locked because
the temperature inside the oven
has not dropped below the locking
temperature.
You have a function error code.
Power outage or surge
Plug on range is not completely
inserted in the electrical outlet.
Gas supply not connected or turned
on.
A fuse in your home may be blown or
the circuit breaker tripped.
Burner parts not replaced correctly.
Burner slots near the electrode, or the
round lighter port on the oval burner,
may be clogged.
Food residue on electrode
What To Do
Tighten or replace bulb. See the Maintenance section for
instructions on how to replace the bulb.
Allow the oven to cool and reset the controls.
See the Cleaning the Oven section.
Press the illuminated Cancel pad. Open the windows to
rid the room of smoke. Wait until the door unlocks. Wipe
up the excess soil and reset the clean cycle.
See the Cleaning the Oven section.
Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or for a
longer period of time.
To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Cleaning the Oven section.
This is temporary.
Lower the rack position of the food.
Press the illuminated Cancel pad. Allow the oven to cool
below the locking temperature.
Press the Dismiss pad and the control will reset. Allow
the oven to cool for one hour. Put the oven back into
operation. If the function code repeats, disconnect all
power to the oven for at least 30 seconds and then
reconnect power. If the function error code repeats again,
visit cafeappliances.com/service.
Reset the clock. If the oven was in use, you must reset
any cooking function.
If UNLOCK CONTROLS appears in the display, the range
control is locked. Turn this feature off to use the range.
See Lock Control in the Settings section in this manual.
Make sure electrical plug is plugged into a live, properly
grounded outlet.
See the Installation Instructions that came with your range.
Replace the fuse or reset the circuit breaker.
See the Care and Cleaning of the range section.
Remove the burners and clean them. Check the electrode
area for burned-on food or grease. See the Care and
Cleaning of the range section.
Lightly polish flat tip of electrode with nail file or sandpaper
until shiny.
49-2000637 Rev. 1