System Presentation; General; Front Control Panel; Starting Screen - Selco Genesis 4000 MSE Instrucciones De Uso

- Connect the red colored
inlet quick connector of the cooling unit.
- Connect the blue colored
outlet quick connector of the cooling unit.
- Connect the MIG torch (23) to the central adapter (24), ensur-
ing that the fastening ring is fully tightened.
- Connect (25) the earth clamp to the negative socket (-) (26) of
the power source.

3 SYSTEM PRESENTATION

3.1 General

They are fully digital multiprocessor systems (data processing on
DSP and communication over CAN-BUS), capable of meeting
the various requirements of the welding world in the best pos-
sible way.
The presence of a powerful microprocessor allows full control of
all the welding functions, making this system suitable for various
types of welding process such as MMA, TIG DC LIFT START,
MIG/MAG.

3.2 Front control panel

1 Power supply
Indicates that the equipment is connected to the mains
and is on.
2 General alarm
Indicates the possible intervention of protection devices
such as the temperature protection (consult the "Alarm
codes" section).
40
water pipe of the torch to the
water pipe of the torch to the
3 Power on
Indicates the presence of voltage on the equipment
outlet connections.
4 7-segment display
Allows the general welding machine parameters to be
displayed during start-up, settings, current and voltage
readings, while welding, and encoding of the alarms.
5 LCD display (3.5"/4.7")
Allows the general welding machine parameters to be
displayed during start-up, settings, current and voltage
readings, while welding, and encoding of the alarms.
Allows all the operations to be displayed instantaneously.
6 Main adjustment handle
Allows entry to set up, the selection and the setting of
the welding parameters.
7 Processes/functions
Let you select the various system functions (welding
process, welding mode, current pulse, graphic mode,
etc.).
8 Synergy
Lets you select a preset welding program (synergy) by
choosing a few simple settings:
- wire type
- gas type
- wire diameter
9 Programs
Allows the storage and management of 64 welding
programs which can be personalised by the operator.

3.3 Starting Screen

When switched on, the generator performs a succession of
checks in order to guarantee the correct operation of the system
and of all the devices connected to it.
At this stage the gas test is also carried out to check the proper
connection to the gas supply system (system for automation and
robotics).

3.4 Test screen

When the side panel (coil compartment) is open, the welding
operations are inhibited.
The test screen appears on the LCD display.
1
Wire feed
2
Wire withdrawal (automation and robotics)
3
Compressed air test (automation and robotics)
4
Gas test
5 Wire speed
Allows the regulation of the wire feed rate.
Minimum 1 m/min, Maximum 22 m/min,
Default 1.0m/min