Thrane & Thrane EXPLORER 500 Manual Del Usuario página 6

NOTE: When the display shows READY, the terminal automatically activates
the LAN interface if the cable is connected and the interface is enabled. If
you are not going to use the LAN connection, remove the cable or disable
the LAN interface to avoid being charged for any transmission through this
interface.
You are now ready to make phone or fax calls, browse the Internet or check
your e-mails, send files, run a video conference and much more.
MAKING A CALL FROM THE EXPLORER
If you are using a Bluetooth handset, the handset must be paired and placed close
to the EXPLORER 500. For information on pairing, see the section BLUETOOTH
PAIRING at the end of this document.
To make a call from a phone connected to the EXPLORER 500, dial
00 <country code> <phone number> followed by # or off-hook key.
Example: To call Thrane & Thrane in Denmark: (+45 39558800),
dial 00 45 39558800 followed by # or off-hook key.
NOTE: There are two audio qualities: Standard voice and 3.1 kHz Audio.
To force the call to use Standard voice, dial 1* before the number. To force the call
to use 3.1 kHz Audio, dial 2* before the number.
MAKING A CALL TO THE EXPLORER
To make a call to a phone connected to the EXPLORER 500, dial
+870 <mobile number>
+ is 00 for Europe and many other countries.
NOTE: There are two voice numbers, one for 3.1 kHz Audio and one for Standard
voice.
500
®
500
®