Use; Switching The Appliance On And Off; Switching The Work Lamp On And Off; Setting Rotational Speed - Parkside PMB 1100 A1 Traducción Del Manual De Instrucciones Original

NOTE
► Make sure that the direction arrow on the
saw blade (if any) is the same as the one
on the rubber wheels
♦ Insert the saw blade
wheels.
♦ Retighten the saw blade clamping lever
turning it clockwise
♦ Replace the two protective covers
WARNING! RISK OF INJURY!
► Only operate the appliance with the
protective covers fitted
♦ Perform a test run by briefly switching the ap-
pliance on and off a few times to determine
whether the saw blade is correctly seated.
WARNING! RISK OF INJURY!
►
Keep your body away from the sawing
area during the test run!

Use

Switching the appliance on and off
Switching on:
♦ Hold down the On/Off switch
Switching off:
♦ Release the On/Off switch
Switching the work lamp on and off
Switching on:
♦ Move the light switch
The work lamp lights up.
Switching off:
♦ Move the light switch
The work lamp goes out.

Setting rotational speed

♦ Adjust the speed setting wheel
between 1 and 6.
PMB 1100 A1
.
around the two rubber
again.
.
!
.
.
to position I.
to position 0.
to a position

Working procedures

♦ Secure the workpiece against slipping, e.g. with
the vice of the saw table.
♦ Use the weight of the saw when sawing.
Do not exert any additional pressure.
♦ Wait until the saw has reached its full speed
before carefully bringing it into contact with the
by
workpiece.
♦ If the saw blade
ance immediately.
♦ Do not twist the saw blade
the cut.
WARNING! RISK OF INJURY!
► Do not remove the workpiece until the saw
has come to a standstill.

Cleaning and maintenance

WARNING! RISK OF INJURY!
► Always remove the power plug from the
wall socket before carrying out any work
on the appliance.
■ Store the appliance and the saw blades in a
dry and dust-free location.
■ The appliance must always be clean and free
of oil or grease.
■ Use a soft, dry cloth to clean the housing.
■ The carbon brushes should only be replaced
by the service centre or an authorised specialist
workshop.
■ Never obstruct the ventilation openings.
■ Remove any adhering sawdust with a brush.
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
blocks, switch off the appli-
while making
GB │ MT │ │
43 ■