How To Assembly The Blades & Light Kit - Fanimation The Benito Manual Del Propietário

How to Assemble the Blades and Light Kit
1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade
arm. With a Phillips screwdriver, tighten 3/16-24 x
7.5 mm washer head screws and fiber washers to
secure the blade to the blade arm (Figure 1).
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Secure the blade holders to the motor support
using the 1/4-20 x 14 mm screws through the holes
located on the side of the motor support (Figure 2).
Periodically check blade holder hardware and
NOTE:
resecure if necessary.
WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
3. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws.
Assemble the light plate upper assembly to the
support bracket using the two key slots in the
socket plate. Replace the third screw and securely
tighten all three screws (Figure 3).
3/16-24 x 7.5 mm WASHER
HEAD SCREW AND FIBER
WASHER (3 each per blade)
HARDWARE USED:
3/16-24 x 7.5 mm
WASHER HEAD
SCREWS
FIBER WASHER
HARDWARE USED:
1/4-20 x 14 mm
SCREWS
10
BLADE
BLADE HOLDER
Figure 1
x 15
x 15
BLADE HOLDER
1/4"-20 x 14 mm SCREWS
(2 per assembly)
MOTOR SUPPORT
Figure 2
x 10
SCREWS (3)
MOTOR
ASSEMBLY
LIGHT PLATE
UPPER
ASSEMBLY
SUPPORT
BRACKET
Figure 3