Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR CLEANING
SYSTEM
if you have any problems operating your pressure
washer, please call the pressure washer helpline at
1=800-222-3136.
Pressure
Washer
Location
Pressure Washer Clearance
1
• Keep
at least 5 fL (152 cm) clearance
on all sides of
pressure
washer
including
overhead.
Place pressure washer in a well ventilated area, which
will allow for removal of deadly exhaust gas. DO NOT
place pressure washer where exhaust gas could
accumulate and enter inside or be drawn into a
potentially occupied building. Ensure exhaust gas is
kept away from any windows, doors, ventilation
intakes or other openings that can allow exhaust gas
to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when
_ositioning pressure washer.
WARNING
Operate
pressure
washer
ONLY
outdoors.
Keep
exhaust
gas from entering
a confined
area through
windows,
doors,
ventilation
intakes
or other openings.
DO NOT operate
pressure
washer
inside
any building
or
enclosure,
even
if doors
or windows
are open.
To Start Your C_eaning
System
To start your engine-powered
cleaning system for the
first time, follow these instructions step-by-step. This
information also applies whenever you start the engine
after you have let the pressure washer sit idle for at
least a day.
1.
Place pressure washer near an outside water
source capable of supplying water at a flow rate
greater than 3.3 gallons per minute and no less
than 20 PSI at pressure washer end of garden
hose.
2.
Check that high pressure hose is tightly connected
to spray gun and pump. See "Assembling Your
Pressure Washer" for illustrations.
3.
Make sure unit is in a level position.
4.
Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
• Damage to equipment will result from failure to follow
this instruction.
5.
Squeeze
trigger on gun to purge
pump system
of
air and impurities.
6.
Attach
nozzle
extension
to spray
gun. Tighten
by
hand.
.
Choose ProjectPro
TM
nozzle you want to use, pull
back on collar of nozzle extension, insert nozzle
and release collar. Tug on nozzle to make sure it
is securely in place. See "How to Use
ProjectPro
TM
Nozzle System".
8.
Engage trigger lock to spray gun trigger.
Typical Pressure
Washer Shown
Trigger Lock
Exhaust Port
10
Publicidad
