Publicidad
Idiomas disponibles
Idiomas disponibles
Attach
Hose Reel
Attach hose reel to handle as shown on page 6
according to instruction sheet included with hose reel.
NOTE: There may be small tube adapters included
with the hose reel kit that is not used on this model.
IMPORTANT:
You must take the hose off the reel
when operating your pressure washer. The reel is for
hose storage purposes only.
Attach
Chemicam Hose to Pump
Attach chemical hose to chemical injection fitting on
pump.
jf
Add Engine
OH
CAUTION!
Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
1.
Place pressure washer on a level surface.
2.
Clean area around oil fill and remove oil dipstick.
3.
Using oil funnel (optional), slowly pour entire
contents of provided oil bottle (18 oz.) into oil fill
opening.
4.
Replace oil dipstick and fully tighten.
NOTE: See the section "Oil" on page 18 to review oil
recommendations.
Add Fuel
NOTE: This gasoline engine is certified to operate on
gasoline. Exhaust Emission Control System: EM
(Engine Modifications).
WARNING
WHEN
ADDING
FUEL
Turn pressure
washer
OFF and let it cool at least 2
minutes
before
removing
fuel cap. Loosen
cap slowly
to
relieve
pressure
in tank.
Fill or drain fuel tank outdoors.
DO NOT overfill
tank. Allow space
for fuel expansion.
Keep fuel away from sparks,
open
flames,
pilot lights,
heat, and other
ignition
sources.
DO NOT light a cigarette
or smoke.
1.
Use clean, fresh, regular UNLEADED fuel with a
minimum of 77 octane with equipment. DO NOT
use fuel which contains Methanol. DO NOT mix oil
with fuel.
2.
Clean area around fuel fill cap, remove cap.
3.
Slowly add regular unleaded fuel to fuel tank. Be
careful not to overfill. Allow about 1.5" of tank
space for fuel expansion, as shown here.
4.
Install fuel cap and wipe up any spilled fuel.
CAUTRON! Alcohol-blended
fuels (called gasohol,
ethanol or methanol) can attract moisture, which leads
to separation and formation of acids during storage.
Acidic gas can damage the fuel system of an engine
while in storage.
To avoid engine problems, the fuel system should be
emptied before storage of 30 days or longer. Drain the
fuel tank, start the engine and let it run until the fuel
lines and carburetor are empty. Use fresh fuel next
season. See "Storage" on pages 21-22 for additional
information.
NEVER use engine or carburetor cleaner products in
the fuel tank as permanent damage may occur.
Fresh Start Fuel Cap
Adding fuel preserver helps keep fuel fresh and
carburetors clean for easier starting, all season long.
This new fuel cap automatically
drips concentrated
fuel preserver into your fuel tank.
immediately.
,6-di-tret-butylpheno{
(128-39-2)
and aliphatic
petroleum
distillate (64742-47-8)
1.
Place cartridge into fuel cap.
Publicidad
