Porter Cable PCC650 Manual De Instrucciones página 8

Leaving the Battery in the Charger
The charger and battery pack can be left connected with the LED glowing indefinitely.
The charger will keep the battery pack fresh and fully charged. This charger features
an automatic tune-up mode which equals or balances the individual cells in the battery
pack to allow it to function at peak capacity. Battery packs should be tuned up weekly
or whenever the battery no longer delivers the same amount of work. To use the
automatic tune-up mode, place the battery pack in the charger and leave it for at least 8 hours.
Important Charging Notes
1. Longest life and best performance can be obtained if the battery pack is charged
when the air temperature is between 65°F and 75°F (18°- 24°C). DO NOT charge the
battery pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C).
This is important and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while charging. This is
a normal condition, and does not indicate a problem. To facilitate the cooling of the
battery pack after use, avoid placing the charger or battery pack in a warm environment
such as in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch which turns power off
when you turn out the lights.
c. Move charger and battery pack to a location where the surrounding air
temperature is approximately 65°F - 75°F (18°- 24°C).
d. If charging problems persist, take the tool, battery pack and charger to your
local service center.
4. The battery pack should be recharged when it fails to produce sufficient power on
jobs which were easily done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also charge a partially used pack
whenever you desire with no adverse affect on the battery pack.
FUNCTIONAL DESCRIPTION
Figure A
1. Variable speed switch
2. Lock-off button
3. Tool free blade release
This product uses the batteries and chargers listed below.
20V Max* Lithium-Ion Batteries: PCC680L, PCC681L, PCC685L, PCC682L
20V Max* Lithium-Ion Chargers: PCC690L, PCC691L, PCC695L, PCC692L
INSTALLING AND REMOVING THE BATTERY PACk FROM THE TOOL
CAUTION
:
Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACk:
audible click is heard as shown in Figure B. Ensure battery pack is fully seated and
fully latched into position.
TO REMOVE BATTERY PACk:
shown in Figure C and pull battery pack out of tool.
OPERATION
WARNING:
the saw blade has stopped, and the battery is removed. Used saw blades can be hot.
SWITCHING ON AND OFF
The tool is equipped with a switch lock-off feature to prevent unintentional operation.
- To switch the tool on, press the lock off button (2) to the left, then squeeze press the
variable speed switch (1). The tool speed depends on how far you depress the switch.
- To switch the tool off, release the variable speed switch.
NOTE:
This tool has no provision to lock the switch in the ON position, and should
never be locked in the ON position by any other means.
BLADE INSTALLATION -FIGURES D, E
WARNING:
Before attempting any of the following operations, make sure that the
Before attempting any of the following operations, make sure that
4. Blade
5. Shoe
6. Orbital Action Selector
Insert battery pack firmly into tool until an
Depress the battery release button (C1) as
8