Assembly Preparation; Assembly Instructions; Securing Feet To Support Legs; Securing Support Plates And Caster Wheels - Navigator PB850G Guía De Montaje

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss
through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.

1. SECURING FEET TO SUPPORT LEGS

Parts Required:
1 x Left Front Leg (#9)
1 x Left Back Leg (#10)
1 x Left Front Leg Trim Piece (#13)
Left Back Leg Trim Piece (#14)
1 x
Screw (#D)
6 x
Installation:
• Use three screws to attach the Left Front Leg Trim Piece to the Left Front
Leg for locking caster wheel. Continue to install the Left Back Leg for locking
caster wheel and Left Back Leg Trim Piece.

2. SECURING SUPPORT PLATES AND CASTER WHEELS

Parts Required:
1 x Left Front Leg (#9)
1 x Left Back Leg (#10)
1 x Left Bottom Support Plate (#18)
1 x Short Support Plate (#19)
Swivel Caster with Brake (#15)
2 x
Screw (#D)
8 x
Installation:
• Install one Short Support Plate to the side of the unit between of a Front and
Back Support Legs using four screws. Repeat the same installation to mount
the Bottom Support Plate to the same legs.
• Insert each Locking Caster Wheel into the Bottom of each Support Leg by
hand-tightening into the hole. Ensure the Locking Caster Wheel is inserted
completely by ensuring it cannot rotate any further.
NOTE: Make sure Bottom Support Plate is facing up with correct direction.

ASSEMBLY PREPARATION

ASSEMBLY INSTRUCTIONS

Customer Service for parts: Monday
®
1
10
9
13
2
10
9
19
18
15
14
15
5