Urrea 23622 Manual De Usuario página 7

6
3
5
INSTALLING ADJUSTMENT HANDLE
• Remove the pump assembly from the box .In
addition to the pump unit , there would be a
Lever Handle placed separately.
• Assemble the Lever Handle with the Connec-
ting Link.
• You have a choice of 3 holes into which the
pump piston could be assembled.
1. Hole Closest to the Connecting Link: Assem-
bly of the piston into this hole allows the pump
to develop High pressure upto 4000 PSI (275
BAR) & deliver 4 gm of grease per stroke. This
position is suggested when using thick grease.
2. Hole Farthest from the Connecting Link: As-
sembly of piston into this hole allows the pump
to deliver high volume of grease upto 9 gms
per stroke & a pressure upto 2000 PSI. This po-
sition is ideal when using thin grease.
3. Middle Hole: Assembly of piston into this
hole allows the pump to develop upto 3000 PSI
7
1
2
4
E N G L I S H •
(206 BAR) pressure & deliver approx. 7 gms of
grease per stroke. This position is good for all
general purpose applications.
• Now open the 3 Cover Clamps & remove the
drum cover assembly from the grease drum.
• Clean the inside of the grease drum , ensu-
ring that no foreign particles stay inside.
• Transfer clean grease into the grease drum.
Do not fill the drum till the top, but only till the
Max. Fill Position marked on the drum.
• Now place the Rubber Lining follower plate
onto the grease & push it down. Keep pushing
it till grease starts coming out of the centre
hole. The rubber edges of the follower plate
must rub against the inside walls of the steel
bucket.
• Place the Drum cover assembly back onto the
Grease bucket. When doing so, the steel pump
must be inserted from the centre hole in the
follower plate. Place the drum cover on the
edges of the Grease drum & close all 3 Cover
clamps Variable Handle Setting High Pressu-
re Setting Develops 4000 PSI with grease dis-
charge of 4 gms per stroke High Pressure High
V lume Setting Develops 3000 PSI with grease
discharge of 7 gms per stroke Develops 2000
PSI with grease discharge of over 9 gms per
stroke. Also useful for bulk filling grease guns
High Volume Setting
• Shake the drum a little so as to settle / com-
press the grease inside
• Start operating the lever handle, till grease
starts flowing out of the coupler fitted at the
end of the hose. This
may take upto about 20 strokes when using
the pump for the first time
• If pump still does not dispense grease, then
shake the bucket a little more to compress the
Grease inside.
Additionally open the Air Release Valve on
the Pump Head & operate the lever handle till
grease starts
coming out of valve. This way any trapped air
gets released .Once grease starts coming out,
close the valve.
WARNING: It is recommended that any re-
pairs or service are provided at a qualified service
center.
U ser's manual