Craftsman 139.53914 Manual Del Propietário página 5

Planning (Continued)
ONE-PIECE DOOR INSTALLATIONS
• Generally, a one-piece door does not require
reinforcement. If your door is lightweight, refer to
the information relating to sectional doors in
Installation Step 11.
• Depending on your door's construction, you may
need additional mounting hardware for the door
bracket (Step 11).
Without a properly working safety reversal system,
persons (particularly small children) could be
SERIOUSLYINJUREDor KILLED by a closing garage
door.
• The gap between the bottom of the garage door and
the floor MUST NOTexceed 1/4" (6 ram). Otherwise,
the safety reversal system may not work properly.
• The floor or the garage door MUST be repaired to
eliminate the gap.
ONE-PIECE DOOR WITHOUT TRACK
FINISHED CEILING
Support bracket,
& fastening
hardware is required.
See page 16.
f
Safety Reversing Sensor
Rail
Gap between floor
and bottom of door must not exceed 1/4" (6 mm).
Wall-mounted
D_or Control
ACCESS
Safety Reversing
Sensor
leader
Vail
Motor Unit
CLOSED POSITION
Trolley Stop Bolt
Belt Trolley
Bracket
Door Bracket Emergency
Release
Rope & Handle
Straight Curved
Door Door
Arm Arm •
Garage
ONE-PIECE DOOR WITH TRACK
Access I
Door I
ol
Reversing
Gap between floor Sensor
J and bottom of door
Safety must not exceed 1/4" (6 mm).
Reversing Sensor
CLOSED POSITION 1
Trolley Stop Bolt Belt Trolley
_Nea_l e _ \Bracket DoorArm_ Rail
DOO_..... Doorl ..... )j !_ i_ergenCYRope &
1_ Bracket Straight Release
DGoararg e Arm Handle
5