Menu Overview - SKF TKTL 31 Instrucciones De Uso

7. Menu overview

• Press Mode key (5) for the Maximum (MAX), Minimum (MIN),
Difference between MAX and MIN (DIF) and Average (AVG)
modes. During the measurement, the special modes reading will
be displayed beside the mode icon.
• Press Up key (4) or Down key (2) to change the High Alarm (HAL)
or Lo Alarm (LAL), then press Meas. key (6) to confirm it. When
the reading is outside the High Alarm (HAL) or Lo Alarm (LAL)
limit. The High or Low icon will flash and you will hear a beep
sound.
• Connect the thermocouple with Thermocouple socket (11) and
put the probe in/on the target, the thermometer will display the
temperature automatically without pressing any button. To see
the minimum or maximum data during the probe measurement,
please hold down the Up key (4) or Down key (2).
B E W A R E :
• Affter measuring high temp, the probe may remain HOT for
a while.
** The thermometer will automatically shut off if left idle for more
than 60 sec, unless in PRB mode. (In PRB mode, it will shut off if
left idle for more than 12 minutes.)
• Press Emissivity key (1)
for setting the emissivity
• Press Emissivity key (1),
then press Up key (4) or
Down key (2) to set the
emissivity, then press
Mode key (5) to confirm it.
The emissivity can be
changed from 0.10 (10E)
to 1 (100E).
• Press Mode key (5) for
scrolling more display
function as follows.
Here will show the emissivity
data. (The default emissivity
is 0.95.)
EN 11