Battery Replacement; Warranty - LEM LH410 Instrucciones De Operación

Do not use the instrument if any part of it appears to be
damaged or if a malfunction of the instrument is
suspected.
When using the instrument ensure that your fingers are
behind the protective barrier see Fig. 1
Clean the case periodically by wiping it with a damp
cloth and detergent. Do not use abrasive cleaners or
solvents. Do not immerse the probe in liquids.

5. BATTERY REPLACEMENT

SAFETY WARNING
Before removing the battery cover,
make sure that the instrument is
remote from any live electrical circuit.
When the Low Battery symbol is illuminated in the
display the minimum operating battery voltage has
been reached. Refer to Fig.1. and use the following
procedure to replace the battery.
Unclamp the meter from the conductor, turn it off using
the OFF / Hold power switch. Loosen the captive
screw which secures the battery cover. Lift the cover
through 30° and pull it clear of the probe body as shown
in Fig1. The battery is then accessible. Replace the
battery and re-fit the battery cover and fasten the
screw.
Replacement with other than the specified type of
battery will invalidate the warranty. Fit only Type 9 V
PP3, Alkaline (MN1604 ).

6. WARRANTY

Your LEM HEME clamp on current meter is guaranteed
for one year from the date of purchase against
defective material or workmanship. If the meter fails
during the warranty period, we shall at our discretion,
repair or replace it with a new or reconditioned unit
provided we are satisfied that the failure is due to
defective material or workmanship. To make a claim
under warranty, the meter should be returned to us,
postage prepaid, with a description of the defect. The
use of a battery, other than that specified invalidates
this warranty.
6