Troubleshooting - Skil DL529301 Manual Del Propietário

To Retighten a Loose Chuck
The chuck may become loose on the spindle and develop a wobble. Also, the chuck screw
may become loose, causing the chuck jaws to bind and prevent them from closing.
To tighten a loose chuck or chuck screw:
a. Lock the variable-speed trigger switch by placing the direction-of-rotation selector in the
center position. And set the torque-adjustment ring at Drill mode
battery.
b. Open the chuck jaws.
c. Insert a hex key (not included) into the chuck and tighten the chuck jaws securely. Tap the
hex key sharply with a mallet (not included) in a clockwise direction. This will tighten the
chuck on the spindle.
d. Open the chuck jaws and remove the hex key.
e. Use a Philips screwdriver (not included) to turn the chuck screw counterclockwise to tighten
it.
Cleaning
WARNING
air. Ventilation openings and switch levers must be kept clean and free of foreign
matter. Do not attempt to clean by inserting pointed objects through openings.
WARNING
solvents, ammonia and house hold detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.

TROUBLESHOOTING

Problem
Tool will not start.
LED Worklight
rapidly flashes.
20
The tool may be cleaned most effectively with compressed dry air.
Always wear safety goggles when cleaning tools with compressed
Certain cleaning agents and solvents damage plastic parts. Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning
Cause
1. Battery pack is depleted.
2. Battery pack is not installed
properly.
3. Burned out switch.
1. Tool is over-loaded.
2. Tool is over-temperature.
. Remove the
Remedy
1. Charge the battery.
2. Confirm battery is locked and
secured to the tool.
3. Have the switch replaced by an
Authorized SKIL Service Center or
Service Station.
1. Release the trigger switch.
2. Cool the tool under air flow.