Installation (Fig. 1,3 Y 4) - POBEL DETA 0040 Manual De Instrucciones

ENG

1.4. INSTALLATION (fig. 1,3 Y 4)

1. Connect the equipment to a power outlet using the power cord CA; according to the voltage indicated in
the technical specifications section.
2. Connect the grey hose to the water supply socket M. The other end of the hose, with the filter previously
installed, will be connected to a ¾ "tap.
3. The drain outlet pipe D should be placed in such a position that excess water falls freely to the outside
into a waste pipe about 25 cm below.
4. Place the outlet protector for CO
5. Check that tap G for cleaning is closed before and during the distillation process.
CA S LI
EB
in the hole O designed for it, located on the lid of the tank A.
2
Note: the tap G is only opened for the cleaning step.
B
A O
fig.1
fig.3
D
9
OUTLET PROTECTOR CO
2
REARME
G M
fig.2
fig.4