Connecting The Lamp And Switch Wires - Maxx Ice ILLUMINATED Serie Manual De Instrucciones, Instalación Y Mantenimiento

CONNECTING THE LAMP AND SWITCH WIRES

1. Use a wire cutter or similar tool to remove plastic straps on the top and bottom of front panel (Fig. 9).
2. Use a Phillip's screwdriver to remove screws, then swing front panel open.
3. Find the lamp and switch wires that have been tied to front bottom end rail of ice maker. There are two
wires, the Lamp wire is black and the Switch wire is white.
4. Locate corresponding lamp and switch wires that have been tied to top panel of storage bin.
5. Connect each set of color wire pairs separately. The connectors need to be inserted SECURELY.
NOTE: This bin interior light will only work properly with a matching Maxx Ice Maker hookup.
6. Tidy up connected wires, tie them to front bottom end rail of ice maker. Make sure all wires are pressed
into the recessed slot, made to hold them securely, to avoid damage to wires from falling slabs of ice
during a harvest sequence or when servicing the ice maker.
7. When the ice maker is on, the interior light can be turned ON or OFF automatically by opening or closing
the ice storage bin door.
Plastic Cover
Fig. 9
Lamp Wires (Black)
Switch Wires (white)
2 of 4 Adjustable
Leveling Legs
NOTE: Interior Light utilizes LED lighting to provide long lasting service (Fig. 10).
Fig. 10
Front Panel
Screw
Front/Side Elevation View
7
Bottom End Rail
Ice Bin Storage
Compartment Cover