Casals VNPLI14M-2 Manual De Instrucciones página 7

safer - Let the appliance running with no load for
30 seconds in a safe position. If you no-
ving tice serious vibration or other defects stop
the appliance immediately. Then check the
e be- problem and /or proceed as we describe on
Anomalies and Repair clause.
away - The appliance can be used on surfaces such
se. as: wood, cardboard, plastic, plaster, etc.
ories
Product description and Specifications
ories
ctive. Description
mains 1 Keyless chuck
any 2 Torque adjustment ring.
3 Cooling vents
only, 4 Soft grip
5 Power light
use. 6 Forward/reverse switch
y the 7 On / Off / speed adjustment switch
o its 8 Battery release button
9 Battery
ould 10 Function ring
play 11 Charger
12 Gear Selector
here
C If the model of your appliance does not
eme have the accessories described above,
they can also be bought separately from
es or the Technical Assistance Service.
-free Charging the battery
Caution: A new battery is not fully charged
pera- and must therefore be charged before the
h as appliance is used for the first time.
oths Caution: During the handling of batteries, do
not touch both poles at the same time, as
t dry this will provoke the partial discharge of the
stocked energy therefore affecting longevity.
f the - Charge the battery at an atmospheric tem-
perature of between 4 and 40ºC.
- When the battery is empty, the appliance
is switched off by means of a protective cir-
cuit. The inserted tool no longer rotates.
- Plug the charger (11) into the mains. And
the green pilot light will turn on
- Remove the battery (9) from the appliance
by pressing the battery unlocking button (8)
and pulling the battery out of the appliance
- Insert the battery (9) into the charger (11).
(Fig B)
- The green pilot light will turn off and the
red pilot will turn on to indicate that the bat-
tery is under charging process.
- Once the charge is completed the red pi-
lot light will turn off and green pilot light will
turn on.
- When the battery is charged disconnect
the charger from the mains supply.
- Remove the battery (9) pressing the bat-
tery unlocking button (8) and pulling the bat-
tery out of the appliance.
Instructions for use
Before use:
- Make sure that all the product's packaging
has been removed.
- Ensure that the voltage indicated on the
rating label matches the mains voltage be-
fore plugging in the appliance.
- Before using this product for the first time,
it is important to make a full charge of bat-
teries.
Inserting a bit:
- To open the drill's chuck (1), whilst com-
pletely switched off, take firm hold of the
back part of the chuck and turn the front
part of the chuck counter clockwise.
- Insert the drill bit, screwdriver bit, or other
tool/ accessory required for the task, into
7