Storage And Cleaning; Service And Maintenance - Greenlee GATOR Operación Manual

Storage and Cleaning

To avoid tool damage or compromise of the tool's
insulation barriers: clean the housing with a damp cloth
and mild detergent after every use. Dry completely and
fully retract the ram. Place the tool in the carrying case
and store in a cool dry place. Do not use the carrying
strap to hang or suspend tool. Avoid dropping the

Service and Maintenance

If damage to tool's housing or Tri-Barrier Insulation
Collar is observed or suspected, or if hydraulic oil has
leaked from the tool, do not use the tool. Tool safety
could be compromised. Return tool immediately to
Greenlee at 800-435-0786 for warranty service or repair.
Proper maintenance of the tool including periodic
replacement of the tool's Tri-Barrier Insulation Collar
componentry is required.
On the earlier of either 2 years or 5,000 cycles, Factory
Service of the tool must be completed. Factory
Service includes replacement of tool's di-electric
hydraulic oil, replacement of tool's Tri-Barrier Insulation
Collar componentry and di-electric testing of tool
by trained technicians as well as general review of
mechanical function.
The Tri-Barrier Insulation Collar componentry on the
Routine Service Calendar
Date Placed into Service
Date of First Factory Service
Date of Second Factory Service
Date of Third Factory Service
Date of Fourth Factory Service
Date of Fifth Factory Service
Date of Sixth Factory Service
Date of Seventh Factory Service
Date of Eighth Factory Service
Date of Ninth Factory Service
Date of Tenth Factory Service
Date of Eleventh Factory Service
Do not perform any service or maintenance other
than as described in this manual. Personal injury or
damage to the tool may result.
Greenlee Tools, Inc.
Gator Insulated Battery-Powered In-Line Crimper
®
Service Date
15
tool. If necessary, recharge the batteries. Refer to the
instructions supplied with the battery charger. Store tool
in proper manufacturer provided protective enclosure.
Keep this manual with the tool.
tool must be replaced every
two years. Failure to follow
Tri-Barrier
Insulation
the required Factory Service
Collar
schedule could compromise the
insulating properties of the tool
and result in serious injury.
The tool will alert when the
earlier of either 2 years or
5,000 cycles is approaching and will alert again when
Factory Service is required. When Factory Service date
is approaching or arrived, contact Greenlee Customer
Service. Expedited shipping is available. After contacting
Greenlee Customer Service, the tool should be sent to
the Greenlee Factory Service Center at 4411 Boeing Dr.,
Rockford, IL 61109.
Use this schedule to help track when your tool is due in
for Factory Service.
Notes
The Tri-Barrier Insulating componentry must be
replaced by Greenlee factory technicians every
two years. Failure to replace Tri-Barrier Insulating
componentry may result in personal injury or damage.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070